Intake Manifold and Exhaust System

...

Intake Manifold Removal and Installation

Exploded View Removal 1. Do the battery removal procedure (see page 22-92). 2. Remove the front grille cover: Р’В© 2-door (see page 20-274) Р’В© 4-door (see page 20-274) 3. Remove ...

See also:

In-car Temperature Sensor Replacement
1. Remove the driver's inner dashboard trim (see page 20-167). 2. Disconnect the connector (A), and remove the in-car temperature sensor (B) from the air hose (C). 3. Install the sensor in the ...

LaneWatch TM*
Is an assistance system that allows you to check the passenger side rear areas displayed on the audio/information screen when the turn signal is activated to the passenger’s side. A camera i ...

ATF Feed Pipe Replacement
1. Remove the snap rings (A), the ATF feed pipes (B), and the feed pipe flanges (C) from the end cover (D). NOTE: Replace the end cover, if the 1st clutch ATF feed pipe (E) replacement is require ...