Maintenance

This chapter discusses basic maintenance. ...

Inspection and Maintenance

For your safety, perform all listed inspections and maintenance to keep your vehicle in good condition. If you become aware of any abnormality (noise, smell, insufficient brake fluid, oil resi ...

See also:

Starter Performance Test
1. Remove the starter (see page 4-11). 2. Firmly clamp the starter in a vise. 3. Make a connection for this test using the thickest (gauge) wire possible (preferably the same gauge as used on ...

Valve, Spring, and Valve Seal Installation
Special Tools Required Stem Seal Driver, 30 mm 07PAD-0010000 Valve Spring Compressor Attachment 07757-PJ1010A 1. Coat the valve stems with new engine oil. Install the valves in the valve guides. ...

Valve Seat Reconditioning
1. Inspect the valve stem-to-guide clearance (see page 6-88). If the valve guides are worn, replace them (see page 6-88) before cutting the valve seats. 2. Renew the valve seats in the cylinder h ...