Honda Accord: HomeLink® Universal Transceiver* - Features - Honda Accord 2013-2023 Owner's ManualHonda Accord: HomeLink® Universal Transceiver*

The HomeLink® Universal Transceiver can be programmed to operate up to three remote controlled devices around your home, such as garage doors, lighting, or home security systems.

• Important Safety Precautions

Refer to the safety information that comes with your garage door opener to test that the safety features are functioning properly. If you do not have the safety information, contact the manufacturer.

Before programming HomeLink, make sure that people and objects are out of the way of the garage or gate to prevent potential injury or damage.

When programming a garage door opener, park just outside the garage door’s path.

HomeLink® is a registered trademark of Johnson Controls., Inc.

Before programming HomeLink to operate a garage door opener, confirm that the opener has an external entrapment protection system, such as an “electronic eye,” or other safety and reverse stop features. If it does not, HomeLink may not be able to operate it.

Training HomeLink

If you have not trained any of the buttons in

If you have not trained any of the buttons in HomeLink before, you should erase any previously learned codes. To do this:

• Press and hold the two outside buttons for about 20 seconds, until the red indicator blinks. Release the buttons, and proceed to step 1.
• If you are training the second or third button, go directly to step 1.

Training a Button

Retraining a Button

Retraining a Button

If you want to retrain a programmed button for a new device, you do not have to erase all button memory. You can replace the existing memory code using this procedure:

Erasing Codes

Erasing Codes

To erase all the codes, press and hold the two outside buttons until the HomeLink indicator begins to blink (about 10 to 20 secs). You should erase all codes before selling the vehicle.

If you have any problems, see the device’s instructions, visit www.homelink.com, or call HomeLink at (800) 355-3515.

    Deleting all HDD Data
    Reset all the menu and customized settings, and delete all music data on the HDD. 1. Turn on the audio system and select the HDD mode. 2. Press the SETTINGS button. 3. Rotate to select Aud ...

    Bluetooth® HandsFreeLink®
    Bluetooth® HandsFreeLink® (HFL) allows you to place and receive phone calls using your vehicle’s audio system, without handling your cell phone. Using HFL • HFL Buttons (Pick-up) b ...

    See also:

    DTC Troubleshooting
    DTC P0443: EVAP Canister Purge Valve Circuit Malfunction Special Tools Required Vacuum Pump/Gauge, 0 - 3 0 In.Hg, Snap-on YA4000A or equivalent commercially available NOTE: Before you troubleshoo ...

    Oil Pan Installation
    1. Remove all of the old liquid gasket from the oil pan mating surfaces, the bolts, and the bolt holes. 2. Clean and dry the oil pan mating surfaces. 3. Apply liquid gasket, P/N 08717-0004,0871 ...

    Secondary H02S Replacement
    Special Tools Required 02 Sensor Wrench Snap-on S6176 or equivalent, commercially available 1. Disconnect the secondary H02S 4P connector (A), then remove the secondary H02S (B). 2. Install the ...