Honda Accord: Daytime Running Lights - Operating the Switches Around theSteering Wheel - Controls - Honda Accord 2013-2026 Owner's ManualHonda Accord: Daytime Running Lights

The high beam headlights come on slightly dimmer than normal when the

The high beam headlights come on slightly dimmer than normal when the following conditions have been met:

The parking/daytime running lights come on when the following conditions have

The parking/daytime running lights come on when the following conditions have been met:

• The power mode is ON.

• The power mode is ON.
• The headlight switch is off, or in • The parking brake is released..
• The parking brake is released.

• The ignition switch is in ON .

• The ignition switch is in ON • The headlight switch is off..
• The headlight switch is off.
• The parking brake is released.

The lights remain on even if you set the parking brake. Turning off the ignition switch or setting the power mode to VEHICLE OFF will turn off the daytime running lights.

The high beam headlights return to the original brightness once the headlight

The high beam headlights return to the original brightness once the headlight switch is turned on.

    Fog Lights
    When the low beam headlights are on, turn the fog light switch on to use the fog lights. When the fog lights are on, the indicator in the instrument panel will be on. They go off when the head ...

    Wipers and Washers
    The windshield wipers and washers can be used when the ignition switch is in ON . • MIST The wipers run at high speed until you release the lever. • Wiper switch (OFF, INT, LO, HI) Chan ...

    See also:

    Armrest
    • Using the Rear Seat Armrest Pull down the armrest in the center seat-back. ...

    DTC Troubleshooting
    DTC B1077: Windshield Wiper Auto-stop (AS) Signal Circuit Malfunction NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see ...

    Park Pin Switch Test
    Produced in USA models 1. Remove the center console (see page 20-158). 2. Disconnect the A/T gear position indicator panel light/park pin switch 6P connector (A) from the park pin switch (B). ...