Power Mirrors

...

Circuit Diagram

With navigation system Without navigation system   ...

See also:

Electrical Compass Unit Input Test
1. Remove the rear shelf (see page 20-128). 2. Loosen the bolts (A), then pull out the electrical compass unit bracket (B). 3. Disconnect the 6P connector (C) and remove the mounting bolt ( D ) ...

DTC Troubleshooting
DTC B1127: Driver's Door Key Cylinder Switch Malfunction NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see page 22-134). ...

Tensioner Pulley Replacement
1. Remove the auto-tensioner (see page 4-31). 2. Clamp the auto-tensioner (A) by using two 8 mm bolts (B) and a vise (C) as shown. Do not clamp the auto-tensioner itself, then remove the tensione ...