Honda Accord: Resuming the Set Speed - Cruise Control - Features - Honda Accord 2008-2012 Owner's ManualHonda Accord: Resuming the Set Speed

When you push the CANCEL button, or tap the brake or clutch pedal, the system will remember the previously set cruising speed. To return to that speed, accelerate to above 25 mph (40 km/h), and then press and release the RES/ACCEL button. The CRUISE CONTROL indicator comes on. The vehicle will accelerate to the same cruising speed as before.

Pressing the CRUISE button turns the system completely off and erases the previous cruising speed.

    Canceling Cruise Control
    You can cancel cruise control in any of these ways: Tap the brake or clutch pedal. Push the CANCEL button on the steering wheel. Push the CRUISE button on the steering wheel. ...

    HomeLink Universal Transceiver
    All V6 models The HomeLink universal transceiver built into your vehicle can be programmed to operate up to three remotely controlled devices around your home, such as garage doors, lightin ...

    See also:

    Seat Belt Inspection
    Regularly check the condition of your seat belts as follows: • Pull each belt out fully, and look for frays, cuts, burns, and wear. • Check that the latches work smoothly and the belts retract ...

    Mode Control Motor Test
    NOTE: Before testing the motor, check for HVAC DTCs (see page 21-101). 1. Disconnect the 7P connector from the mode control motor. Incorrectly applying power and ground to the mode control mo ...

    Symptom Troubleshooting
    VSA activation indicator does not go off, and no DTCs are stored NOTE: If the VSA modulator was replaced prior to the activation indicator turning on, do the VSA sensor neutral position memorizati ...