Doors

Component Location Index Rear Door

See also:

Tie-rod End Ball Joint Boot Replacement
Special Tools Required Bearing Driver Attachment, 36 07965-SA50500 1 Disconnect the tie-rod end ball joint from the knuckle (see step 26 on page 17-41). 2. Remove the tie-rod end from the rack e ...

DTC Troubleshooting Index
NOTE: The above DTCs are indicated when the PGM-FI system is selected with the HDS. Some automatic transmission DTCs cause the MIL to come on. If the MIL is on and no DTCs are indicated in the PG ...

Park Lever Stop Inspection and Adjustment
1. Set the park lever in the P position. 2. Measure the distance (A) between the park pawl shaft (B) and the park lever roller pin (C). Standard: 57.7-58.7 mm (2.27-2.31 in) 3. If the measurem ...