Honda Accord: Wiper Motor Test - Wipers/Washers - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Wiper Motor Test

4-door

1. Remove the driver's side wiper arm (see page 22-321).

2. Remove the left side cowl cover (see page 22-321).

3. Disconnect 5P connector (A) from the windshield wiper motor (B).

4. Test the motor by connecting battery power to


4. Test the motor by connecting battery power to terminal No. 3 and ground to terminal No. 2 of the wiper motor connector 5P connector. The motor should run at low speed.

5. Test the motor by connecting battery power to terminal No. 5 and ground to terminal No. 2 of the wiper motor 5P connector. The motor should run at high speed.

6. Connect an analog ohmmeterto terminals No. 4 and No. 2, and run the motor at low or high speed. The needle of the ohmmeter should pulse.

7. If the motor does not run or fails to run smoothly, or there is no pulse, replace the motor.

2-door

1. Remove the driver's side wiper arm (see page 22-321).

2. Remove the left side cowl cover (see page 22-321).

3. Disconnect 5P connector (A) f r om the windshield wiper motor (B).

4. Test the motor by connecting battery power to


4. Test the motor by connecting battery power to terminal No. 3 and ground to terminal No. 4 of the wiper motor 5P connector. The motor should run at low speed.

5. Test the motor by connecting battery power to terminal No. 5 and ground to terminal No. 4 of the wiper motor 5P connector. The motor should run at high speed.

6. Connect an analog ohmmeter to terminals No. 1 and No. 4, and run the motor at low or high speed. The needle of the ohmmeter should pulse.

7. If the motor does not run or fails to run smoothly, or there is no pulse, replace the motor.

    WiperA/Vasher Switch Test / Replacemen
    1. Remove the steering column covers {see page 20-181). 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the ...

    Washer Motor Test
    1. Remove the right inner fender (see page 20-290). 2. Disconnect the 2P connector (A) from the windshield washer motor (B). USA models 3. Test the motor by connecting battery power to term ...

    See also:

    Heating and Cooling System*/ClimateControl System* Maintenance
    Dust and Pollen Filter The heating and cooling system*/climate control system* is equipped with a dust and pollen filter that collects pollen, dust, and other debris in the air. The Maintenance ...

    Grab Handle Removal/Installation
    Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Use the appropriate tool from the KTC trim tool set to a ...

    Component Location Index
    ...