Honda Accord: Wiper Blade Replacement
Removal
1. Lift the wiper arms off the windshield.
2. Pull up and hold the tab (A), and slide the wiper blade assembly (B) toward the tabs until it releases from the wiper arm (C).
NOTE: The illustration shows 4-door.
3. Pull back the end of the blade and slide out the old blade (A).
NOTE: The illustration shows 4-door.
Installation
1. Align the groove (A) of the each rail (B) and a new blade ( C ).
4-door
2. Install the new blade with the rails into the blade holder in the reverse order of removal.
3. Install the wiper lade assemblies onto the wiper arms in the reverse order of removal .
4. Test the wipers by turning the wiper switch on , If the blades slip , turn the wipers witch off and seat the wiper blade securely.
Washer Reservoir Replacement
1. Remove the right inner fender (see page 20-290).
2. Disconnect the 2P connector(s) (A) from the washer
motor (B) and the washer fluid level switch (Canada
models).
Washer Reservoir Capacity:
...
Wiper Arm/Nozzle Adjustment
4-door
1. Turn the wiper switch ON, and then back OFF.
2. W h e n t h e w i p e r a r m s s t o p at t h e p a r k p o s i t i o n , c
o n f i rm that t h e y a r e at t h e s t a n d a r d posi ...
See also:
Side Airbag Replacement
NOTE: If replacing the side airbag after deployment,
refer to Component Replacement/Inspection After
Deployment (see page 24-208) for a complete list of
other parts that must also be replaced.
Rem ...
Checking Loads
The best way to confirmthat all
loads are within limits is to check
them at a public scale. For public
scales in your area, check your local
phone book, or contact your trailer
dealer or ren ...
Rear Seat Armrest Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
4-door
NOTE:
- Use the appropriate tool from the KTC trim tool s ...