Honda Accord: Windshield Washers - Maintenance - Honda Accord 2008-2012 Owner's ManualHonda Accord: Windshield Washers

Check the level in the windshield

Check the level in the windshield washer reservoir at least monthly during normal use.

Check the fluid level by removing the cap and looking at the level gauge.

On Canadian models: The low washer level indicator comes on when the level is low.

Fill the reservoir with a good-quality

Fill the reservoir with a good-quality windshield washer fluid. This increases the cleaning capability and prevents freezing in cold weather.

When you refill the reservoir, clean the edges of the windshield wiper blades with windshield washer fluid on a clean cloth. This will help to condition the blade edges.

Do not use engine antif reeze or a

Do not use engine antif reeze or a vinegar/water solution in the windshield washer reservoir. Antif reeze can damage your vehicle’s paint, while a vinegar/water solution can damage the windshield washer pump. Use only commercially-available windshield washer f luid.

    Engine Coolant
    Adding Engine Coolant If the coolant level in the reserve tank is at or below the MIN line, add coolant to bring it up to the MAX line. Inspect the cooling system for leaks. Always use Hond ...

    Transmission Fluid
    ...

    See also:

    A/C Signal Circuit Troubleshooting
    NOTE: • If the blower motor does not run at all speeds, the A/C compressor will be inoperative. Run the self-diagnostic function, and check for DTC 12. Before performing any other troubleshoo ...

    Gearbox Mount Cushion Replacement
    1. Remove the steering gearbox (see page 17-37). 2. Position a 40 mm socket (A) on the flange part of the gearbox housing with a washer (B), a 10 x 150 mm flange bolt (C), and a 10 mm nut (D) as ...

    HFL System Troubleshooting
    NOTE: • Before doing this troubleshooting, refer to General Troubleshooting Information (see page 23-254) to make sure the phone is compatible and configured correctly. • You must be ...