Honda Accord: Wind Deflector Replacement
NOTE: When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
1. Open the glass fully.
2. Remove the deflector links (A) from both sides.
3. Remove the wind deflector (A).
4. Pry up on the deflector arm bases (A) with a flat-tip screwdriver, and release the hooks (B), then remove the bases with deflector arm springs (C) from both sides.
5. Install the deflector in the reverse order of removal.
6. Reset the moonroof control unit (see page 22-371).
Glass Weatherstrip Replacement
1 . Remove the moonroof glass (see page 20-91). 2. Place a piece of masking tape (A) on the middle of the front edge of the moonroof glass (B). Make sure that the tape is on the glass only, and i ...Drain Channel Replacement
1. Remove the moonroof glass (see page 20-91). 2. On both sides, slide the glass brackets (A) with the moonroof switch to the position where the moonroof normally tilts up and disconnect the drai ...See also:
Replacing a Front Side Marker Light Bulb
1. To change the bulb on the driver’s
side, start the engine, turn the
steering wheel all the way to the
right, then turn off the engine. To
change the bulb on the passenger’s
side, tu ...
Accessories and Modifications
Modifying your vehicle, or installing
some non-Honda accessories, can
make your vehicle unsafe. Before
you make any modifications or add
any accessories, be sure to read the
following inform ...