Honda Accord: Wheel Bearing End Play Inspection
1. Raise and support the vehicle (see page 1-13).
2. Remove the wheels.
3 . Install suitable flat washers (A) and the wheel nuts.
Tighten the nuts to the specified torque to hold the brake disc securely against the hub.
Front
Rear
4. Attach the dial gauge. Place the dial gauge against the hub flange.
5. Measure the bearing end play while moving the brake disc inward and outward.
Wheel bearing end play:
Front/Rear: 0—0.05 mm (0—0.002 in)
6. If the bearing end play measurement is more than the standard, replace the wheel bearing or the hub bearing unit.
Wheel Alignment
The suspension can be adjusted for front and rear toe.
Pre-Alignment Checks
For proper inspection and adjustment of the wheel ;
alignment, do these checks:
1. Release the parking brake-to avoid an ...
Wheel Runout Inspection
1. Raise and support the vehicle (see page 1 -13).
2. Check for a bent or deformed wheel.
3. Set up the dial gauge as shown, and measure the
axial runout by turning the wheel.
Front and rear w ...
See also:
Steering Gearbox Overhaul
Exploded View
Special Tools Required
-Cylinder End Seal Remover Attachment
07TAF-SZ50100
-Valve Seal Ring Sizing Tool 07NAG-SR3090A
-Sleeve Seal Guide, 35.9 x 37
07YAG-S2X0100
-Sizing Tool, ...
Glove Box Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and Equipment
Program; call 888-424-6857
SRS components are located in this area. Review the
SRS component l ...
Fuel Information
• Fuel recommendation
Use of a lower octane gasoline can cause a persistent, heavy metallic
knocking noise
that can lead to engine damage.
• Top tier detergent gasoline
Because the level ...