Honda Accord: Washer Motor Test
1. Remove the right inner fender (see page 20-290).
2. Disconnect the 2P connector (A) from the windshield washer motor (B).
USA models
3. Test the motor by connecting battery power to terminal No. 2 and ground to terminal No. 1 of the washer motor. The motor should run.
• If the motor does not run or fails to run smoothly, replace it.
• If the motor runs smoothly, but little or no washer fluid is pumped, check for a disconnected or blocked washer hose, or a clogged washer motor outlet.
Wiper Motor Test
4-door
1. Remove the driver's side wiper arm (see page
22-321).
2. Remove the left side cowl cover (see page 22-321).
3. Disconnect 5P connector (A) from the windshield
wiper motor (B).
4. ...
Washer Fluid Level Switch Test
Canada models
1. Remove the right inner fender (see page 20-290).
2. Disconnect the 2P connector (A) from the washer fluid
level switch (B).
3. Remove the washer fluid level switch from the
w ...
See also:
In-car Temperature Sensor
Replacement
1. Remove the driver's inner dashboard trim (see page
20-167).
2. Disconnect the connector (A), and remove the in-car
temperature sensor (B) from the air hose (C).
3. Install the sensor in the ...
Cam Chain Case Oil Seal
Installatio
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Attachment, 52 x 55 mm 07746-0010400
1. Clean and dry the crankshaft oil seal.
2. Apply a light coat of new engine oil to the lip of ...
Outside Air Temperature Sensor Test
1 Remove the outside air temperature sensor (see page
22-353).
2. Dip the sensor in ice water, and measure the
resistance. Then pour warm water on the sensor, and
check for a change in resistanc ...