Honda Accord: Washer Fluid Level Switch Test - Wipers/Washers - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Washer Fluid Level Switch Test

Canada models

1. Remove the right inner fender (see page 20-290).

2. Disconnect the 2P connector (A) from the washer fluid level switch (B).

3. Remove the washer fluid level switch from the


3. Remove the washer fluid level switch from the washer reservoir.

NOTE: Fluid may flow out of the opening.

4. Check for continuity between terminals No. 1 and No.

2 in each float position.

• There should be continuity when the float is down.

• There should be no continuity when the float is up.

5. If the continuity is not as specified, replace the switch.

    Washer Motor Test
    1. Remove the right inner fender (see page 20-290). 2. Disconnect the 2P connector (A) from the windshield washer motor (B). USA models 3. Test the motor by connecting battery power to term ...

    Wiper Motor Replacement
    Removal 1. Open the hood. Remove the caps (A) and nuts (B). NOTE: The illustration shows 4-door. 2. Close the hood, then spread protective cloths (A) on the hood to avoid scratching the hood e ...

    See also:

    Rearview Mirror Harness Cover Base Replacement
    4-door with Automatic Dimming Rearview Mirror NOTE: t Put on gloves to protect your hands. - Wear eye protection while cutting the glass adhesive with piano wire. 1. Remove these items: - R ...

    Circuit Diagram
    With navigation system Without navigation system   ...

    HVAC Control Power and Ground Circuit Troubleshooting
    1. Check the No. 16 (7.5 A) fuse in the driver's under-dash fuse/ relay box. Is the fuse OK? YES-Go to step 2. NO-Replace the fuse, and recheck. If the fuse blows again, check for a short in ...