Honda Accord: VTEC/VTC
- Component Location I n d e x
- DTC Troubleshooting
- VTC Oil Control Solenoid Valve Removal/Test/lnstallation
- CMP Sensor A Replacement
- Rocker Arm Oil Control Valve Removal/Installation
- Rocker Arm Oil Pressure Switch Removal/Installation
- Rocker Arm Oil Pressure Switch A Removal/Installation
- Rocker Arm Oil Pressure Switch B Removal/Installation
Accelerator Pedal Module
Removal/Installation
1. Disconnect the APP sensor connector (A).
2. Remove the accelerator pedal module (B).
NOTE: The APP sensor is not available separately. Do
not disassemble the accelerator pedal module.
3. ...
Component Location I n d e x
All models except PZEV
...
See also:
Fuel Pump Circuit Troubleshooting
If you suspect a problem with the fuel pump, check that
the fuel pump actually runs; when it is on, you will hear
some noise if you listen to the fuel fill port with the fuel
fill cap removed. The ...
A/C Signal Circuit Troubleshooting
NOTE:
• If the blower motor does not run at all speeds, the A/C
compressor will be inoperative. Run the
self-diagnostic function, and check for DTC 12. Before
performing any other troubleshoo ...
EVAP Canister Replacement
1. Raise the vehicle on a lift.
2. Remove the wheel sensor harness clamps (A)
3. Support the rear subframe with a transmission jack
and a wooden block as shown.
4. Remove the rear subframe m ...