Honda Accord: VSA System Components
- Component Location Index
- General Troubleshooting Information
- DTC Troubleshooting Index
- Symptom Troubleshooting Index
- System Description
- Circuit Diagram
- DTC Troubleshooting
- Symptom Troubleshooting
- Steering Angle Sensor Replacement
- Yaw Rate-Lateral Acceleration Sensor Replacement
- VSA Sensor Neutral Position Memorization
- VSA Off Switch Test
- VSA Modulator-Control Unit Update
- VSA Modulator-Control Unit Removal and Installation
- Wheel Speed Sensor Replacement
Parking Brake Cable Replacement
Exploded View
NOTE:
- The parking brake cables must not be bent or
distorted. This will lead to stiff operation and
premature cable failure.
- Refer to the Exploded View as needed during this ...
See also:
Hood Seal and Hood Molding
Replacement
NOTE: Take care not to scratch the hood.
1. Detach the clips (A) with a clip remover, then remove
the hood seal (B). On Canada models: Detach the clips
(C), then remove the hood molding (D).
2-d ...
Frame Brace Replacement
Strut Brace Replacement
1. Remove the cowl cover (see page 20-278).
2. Disconnect the brake booster vacuum hose (A) from
the strut brace (B).
3. Remove the nuts from the top of the damper, and ...
Driver's Under-dash Fuse/Relay Box
(MICU) Removal and Installation
Special Tools Required
Relay Puller 07AAC-000A1A0
USA models
NOTE; SRS components are located in this area. Review
the SRS component locations 4-door (see page 24-21),
2-door (see page 24-23), an ...
