Honda Accord: VSA Sensor Neutral Position Memorization
NOTE: Do not press the brake pedal during this procedure.
1. Park the vehicle on a flat and level surface, with the steering wheel in the straight ahead position.
2. With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) under the driver's side of the dashboard.
3. Turn the ignition switch to ON (II).
4. Make sure the HDS communicates with the vehicle and the VSA modulator-control unit. If it doesn't, troubleshoot the DLC circuit (see page 11-181).
5. Select VSA ADJUSTMENT with the HDS, and follow the screen prompts.
NOTE: See the HDS Help menu for specific instructions.
6. Turn the ignition switch to LOCK (0).
Yaw Rate-Lateral Acceleration Sensor Replacement
NOTE: - Do not damage or drop the sensor as It Is sensitive. - Do not use power tools when replacing the sensor. 1. Turn the ignition switch to LOCK (0). 2. Remove the center console (see ...VSA Off Switch Test
1. Turn the ignition switch to LOCK (0). 2. Remove the driver's dashboard lower cover {see page 20-166). 3. Push out the VSA OFF switch (A) from the driver's dashboard lower cover. 4. Check ...See also:
Relays
Power Relay Test
Special Tools Required
Relay Puller 07AAC-000A1A0
Use this chart to identify the type of relay, then do the
test listed for it.
*1:'08-09 models
*2: Carefully remove the relay ...
Bluetooth® HandsFreeLink®
Bluetooth® HandsFreeLink® (HFL) allows you to place and receive phone calls
using
your vehicle’s audio system, without handling your cell phone.
Using HFL
• HFL Buttons
(Pick-up) b ...
Storing a Driving Position in Memory
Store a driving position only when
the vehicle is parked.
1. Turn the ignition switch to the ON
(II) position. You cannot add a
new driving position to the
memory unless the ignition switch
...