Honda Accord: Voice Control Switch Test - Navigation System - Audio, Navigation, and Telematics - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Voice Control Switch Test

1. Remove the voice control switch (see page 17-7).

2. Measure the resistance between terminals No. 2 and


2. Measure the resistance between terminals No. 2 and No. 4 in each switch position according to the table.

3. If the resistance is not as specified, replace the voice


3. If the resistance is not as specified, replace the voice control switch (see page 23-241).

    GPS Antenna Removal/Installation
    1. Remove the rear shelf (see page 20-128). 2. Disconnect the GPS antenna connector (A), and remove the bolt (B). 3. Detach the harness clips, and remove the GPS antenna (C). 4. Install the ...

    Voice Control Switch Replacement
    1. Remove the steering wheel (see page 17-6). 2. Remove the voice control switch (see page 17-7). 3. Install the voice control switch in the reverse order of removal. ...

    See also:

    MICU Input Test
    NOTE: # Before t e s t i n g , t r o u b l e s h o o t the m u l t i p l e x i n t e g r a t e d control unit first, using B-CAN System D i a g n o s i s Test Mode A (see page 22-134). • B ...

    Symptom Troubleshooting
    The HFL digits do not go away from the audio-HVAC subdisplay or the audio HVAC display after pressing the HFL BACK button 1. Connect the HDS to the DLC (see page 23-252). 2. Clear the DTCs with ...

    Valve Clearance Adjustment
    Special Tools Required . Locknut Wrench 07MAA-PR70120 . Adjuster 07MAA-PR70110 NOTE: Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) and monitor the engine coolant temp ...