Reverse Idler Gear Removal and Installation

Removal 1. Remove the bolt (A) securing the reverse idler gear shaft holder (B). 2. Install a 5 x 0.8 mm bolt (C) in the reverse idler gear shaft (D), and pull it to remove the reverse idler gea ...

Valve Body and ATF Strainer Removal

1. Remove the ATF feed pipes (A) and the ATF joint pipes (B). 2. Remove the ATF strainer (C) (two bolts). 3. Remove the regulator valve body (D) (eight bolts). 4. Remove the stator shaft (E) and ...

See also:

Symptom Troubleshooting Index
...

Ignition Switch
WARNING Removing the key from the ignition switch while driving locks the steering. This can cause you to lose control of the vehicle. Remove the key from the ignition switch only when p ...

Lap/Shoulder Belt
The lap/shoulder belt goes over your shoulder, across your chest, and across your hips. To fasten the belt, insert the latch plate into the buckle, then tug on the belt to make sure the buckl ...