Under-hood Fuse/Relay Box

Removal and Installation Special Tools Required Relay Puller 07AAC-000A1A0 NOTE; The under-hood fuse/relay box is a part of the left engine compartment wire harness, and it cannot be replaced by ...

Driver's Under-dash Fuse/Relay Box (MICU) Removal and Installation

Special Tools Required Relay Puller 07AAC-000A1A0 USA models NOTE; SRS components are located in this area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), an ...

See also:

A/C Compressor Clutch Overhaul
Special Tools Required • A/C Clutch Holder Robinair 10290 or Kent-Moore J37872, commercially available • A/C Clutch Holder Honda Tool and Equipment ACT499A, commercially available 1. Re ...

EVAP Canister Replacement
1. Raise the vehicle on a lift. 2. Remove the wheel sensor harness clamps (A) 3. Support the rear subframe with a transmission jack and a wooden block as shown. 4. Remove the rear subframe m ...

F-CAN Circuit Troubleshooting
1. Turn the ignition switch to LOCK (0). 2. Jump the SCS line with the HDS. 3. Disconnect ECM/PCM connector A (49P). 4. Measure the resistance between ECM/PCM connector terminals A3 and A4. ...