Brake Pedal Position Switch Test

1. Disconnect the 4P connector (A) from the brake pedal position switch (B). 2. Check for continuity between terminals No. 1 and No. 2. • There should be continuity when the brake pedal ...

Component Location index

...

See also:

Reverse Shift Fork Clearance Inspection
1. Measure the clearance between the reverse Idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2. Standard; 0.20-0.59 mm ...

Ignition Switch Test
NOTE: SRS components are located in the area. Review the SRS component locations 4-door (see page 24-21), 2-door (see page 24-23), and precautions and procedures (see page 24-25) before doing repai ...

Closing Force and Opening Drag Check
1. Remove the headliner (see page 20-140). 2. Closing force check: - Cover the leading edge of the glass (A) with a shop towel (B), and attach a spring scale (C) as shown. - Have an assistant ...