Honda Accord: Trunk Pass-through Lid Lock Cylinder Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and Equipment Program; call 888-424-6857
4-door
NOTE: - Take care not to scratch the trunk pass-through lid.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Pry up the handle (A) with the appropriate trim tool at both hook areas (B) on the forward side of the trunk pass-through lid (C). Then slide the handle half-way up.
2. Remove the handle (A) from the trunk pass-through lid (B) by sliding it up.
3. Remove the retainer clip (A), then remove the trunk pass-through lid lock cylinder (B) from the handle (C).
4. Install the lock cylinder in the reverse order of removal, and note these items: - Install the retainer clip on the handle, then install the lock cylinder. Be sure the clip is fully seated in the slot on the lock cylinder.
- Make sure the trunk pass-through lid opens properly and locks securely.
Rear Seat Armrest Replacement
Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 4-door NOTE: - Use the appropriate tool from the KTC trim tool s ...Trunk Pass-through Lid Replacement
4-door NOTE: Take care not to tear or damage the seat covers. 1. Fold down the rear seat-back. 2. Remove the screws, and release the hooks (A), then remove the trunk pass-through lid (B). 3 ...See also:
Power Windows
Turn the ignition switch to the ON
(II) position to raise or lower either
window. To open a window, push the
switch down and hold it. Release the
switch when you want the window to
stop. P ...
Brake System Bleeding
NOTE:
- Do not reuse the drained fluid. Use only new Honda
DOT 3 Brake Fluid from an unopened container. Using
a non-Honda brake fluid can cause corrosion and
shorten the life of the system.
- ...
Ignition Key Switch Test
1. Remove the steering column upper and lower covers
(see page 20-181).
2. Disconnect the 6P connector (A).
3. Check for continuity between terminals No. 1 and No.
2.
• There should ...