Honda Accord: Trunk Lid Weatherstrip Replacement - Trunk Lid - Body - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Trunk Lid Weatherstrip Replacement

NOTE: 4-door Is shown; 2-door Is similar.

1. Remove the trunk lid weatherstrip (A) by pulling it off.

2. Locate the painted alignment mark (B or C) on the


2. Locate the painted alignment mark (B or C) on the trunk lid weatherstrip. Align the painted mark in the center of the trunk lid opening, and install the weatherstrip all the way around in the direction shown. Make sure there are no wrinkles in the weatherstrip.

3. Check for water leaks (see step 9 on page 20-57).

    Trunk Lid Torsion Bar Replacement
    Special Tools Required Torsion Bar Assembly Tool 07AAF-SNAA100 1. Remove the trunk lid torsion bars (A) from the torsion bar center clip (B). 3. Remove the torsion bar center clip (A) from the ...

    Trunk Lid Cushion Replacement
    1. Remove the trunk lid cushion (A) by pulling it out to detach the clips. 2. Replace the trunk lid cushion with a new one. 3. Install the trunk lid cushion by pushing on the clip areas until ...

    See also:

    Trunk Lid Latch Replacement
    Special Tools Required KTC Trim Too! Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 NOTE: - Put on gloves to protect your hands. - Take care not t ...

    Front Fender Fairing Replacement
    For Some Models NOTE; - Take care not to scratch the body. - Put on gloves to protect your hands. 1. Remove the front Inner fender as needed (see page 20-290). 2. From the wheel arch, rele ...

    Modifying Your Vehicle
    Removing parts from your vehicle, or replacing components with non-Honda components could seriously affect your vehicle’s handling, stability, and reliability. Some examples are: Lowering ...