Honda Accord: Trunk Lid Dynamic Damper
Replacement
2-door
NOTE: Take care not to scratch the trunk lid.
1. Remove the cover (A) by releasing the hooks (B).
Remove the bolts, and detach the clips, then remove the trunk lid dynamic damper bracket (C) with the trunk lid dynamic damper.
2. Install the damper in the reverse order of removal, and note these items: - If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips and the hooks into place securely.
4-door
NOTE: Take care not to scratch the trunk lid.
1. Remove the cover (A) by releasing the hooks (B).
Remove the bolts (C), then remove the trunk lid dynamic damper (D).
2. Install the damper in the reverse order of removal, and push the hooks into place securely.
Trunk Lid Cushion Replacement
1. Remove the trunk lid cushion (A) by pulling it out to
detach the clips.
2. Replace the trunk lid cushion with a new one.
3. Install the trunk lid cushion by pushing on the clip
areas until ...
Fuel Fill Door
...
See also:
Fluid Replacement
Check the reservoir (A) at regular intervals, and add the
recommended fluid as necessary. Always use Honda
Power Steering Fluid. Using any other type of power
steering fluid or automatic transmissi ...
Connector to Harness Index
Starter Subharness
Engine Wire Harness (M/T)
Engine Wire Harness ( A / T )
*1: PZEV
*2: Except PZEV
CKP Sensor Subharness
Shift Solenoid Wire Harness (A/T)
Transmission Rang ...
Fuel Fill Pipe Removal/Installation
1. Drain the fuel tank (see page 11-309).
2. Remove the fuel fill cap.
3. Remove the left rear wheel.
4. Remove the fuel fill pipe cover (A).
5. Disconnect the quick-connect fittings (A) ( ...