Hood insulator Replacement

For Some Models NOTE; Take care not to scratch the hood. 1. Detach the clips with a clip remover. Remove the hood insulator (A) by pulling it away from the hooks  (B). 2. Install the ins ...

Trunk Lid Adjustment

1. Remove the rear shelf (see page 20-128). 2. Pry up the notches (A) to release the rear hooks (B), and pull up the cap (C) to release the side hooks (D), then remove the cap. 3. Slightly lo ...

See also:

DTC Troubleshooting
DTC 81152: Gauge Control Module (EEPROM) Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see page 22-134). 1. Cle ...

ODS Unit Replacement
Removal 1. Do t h e battery t e r m i n a l disconnection procedure (see page 22-91), t h e n w a i t at least 3 minutes before s t a r t i ng work. 2. Remove t h e f r o n t passenger's seat (s ...

Brake System
• Parking Brake Use the parking brake to keep the vehicle stationary when parking. To apply: Pull the lever fully up without pressing the release button. To release: 1. Pull the lever sli ...