Honda Accord: Transmission End Cover
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Transaxle / Transmission End Cover
- End Cover Removal
- Park Lever Stop Inspection and Adjustment
- Idler Gear Shaft Bearing Replacement
- Selector Control Shaft Oil Seal Replacement
- Selector Centre! Sheft Bearing Replacement
- ATF Feed Pipe Replacement
Park Pin Switch Replacement
Type A Shift Lever
NOTE: The AfT gear position indicator panel light
harness and the park pin switch are not available
separately. Replace the A/T gear position indicator panel
light harness and t ...
End Cover Removal
Special Tools Required
Mainshaft Holder 07GAB-PF50101
1. Remove the three bolts (D) securing the ATF cooler inlet line brackets,
the ATF filter bracket bolts (E), the ATF cooler
line banjo bolts ...
See also:
Cf Under Head Removal
NOTE:
- Use fender covers to avoid damaging painted
surfaces.
- To avoid damage, unplug the wiring connectors
carefully while holding the connector portion.
- Connect the Honda Diagnostic Sys ...
Fluid Replacement
Check the reservoir (A) at regular intervals, and add the
recommended fluid as necessary. Always use Honda
Power Steering Fluid. Using any other type of power
steering fluid or automatic transmissi ...
EVAP Canister Replacement
1. Raise the vehicle on a lift.
2. Remove the wheel sensor harness clamps (A)
3. Support the rear subframe with a transmission jack
and a wooden block as shown.
4. Remove the rear subframe m ...