Differential Thrust Clearance Adjustment

Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 1 Remove trie left driveshaft side oil seal from the transmission housing (see page 13-70). 2. If you removed the 80 mm shim from t ...

Automatic Transmission

...

See also:

Outboard Joint Side
1. Wrap the splines on the driveshaft with vinyl tape (A) to prevent damaging the outboard boot. 2. Install new ear clamp bands (B) and the outboard boot onto the driveshaft, then remove the viny ...

Horn Switch Test
NOTE: Check for a blown No. 10 (20 A) fuse in the under-hood fuse/relay box. If it is blown, check for a faulty horn relay. 1. Turn the steering wheel 180 degrees from the center position and re ...

Valve Stem-to-Guide Clearance Inspection
1. Remove the valves (see page 6-86). 2. Subtract the O.D. of the valve stem, measured with a micrometer, from the I.D. of the valve guide, measured with an inside micrometer or a ball gauge. ...