EVAP Canister Purge Valve Replacement

1. Disconnect the E V A P canister purge valve 2P connector ( A ) . 2. Disconnect the hoses ( B ) , then remove the I V A P canister purge valve ( C ) . 3. Install the parts in the reverse ord ...

Clutch

...

See also:

Under-floorTWC Removal/Installation
1. Raise the vehicle on a lift. 2. Remove the exhaust pipe hangers (A). 3. Remove the under-floor TWC (B). 4. Install the parts in the reverse order of removal with new gaskets (C) and new s ...

Piston, Pin, and Confyssfeg EQC Replacement
Disassembly 1. Remove the piston from the engine block (see page 7-14). 2. Apply new engine oil to the piston pin snap rings (A), and turn them in the ring grooves until the end gaps are lined ...

Ball Joint Boot Inspection / Replacemen
Special Tools Required - Clip Guide, 45 mm 070AG-SJA0300 -Clip Guide, 41 mm 07974-SA50700 1. Check the ball joint boot for weakness, damage, cracks, and grease leaks. NOTE: - If the ball joint ...