Honda Accord: Training HomeLink
Before you begin - If you just received your vehicle and have not trained any of the buttons in HomeLink before, you should erase any previously learned codes before training the first button. To do this, press and hold the two outside buttons on the HomeLink transceiver for about 10 - 20 seconds, until the red indicator flashes.
Release the buttons, then proceed to step 1.
If you are training the second or third buttons, go directly to step 1.
HomeLink is a registered trademark of Johnson Controls, Inc.
As required by the FCC:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Industry Canada Standard RSS-210.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference that may cause undesired operation of the device.
Important Safety Precautions
Refer to the safety information that
came with your garage door opener
to test that the safety features are
functioning properly. If you do not
have this information, contact the
manufacture ...
Bluetooth HandsFreeLink
If equipped
Bluetooth HandsFreeLink (HFL)
allows you to place and receive
phone calls using voice commands,
without handling your cell phone.
To use HFL, you need a Bluetoothcompatible
cell ...
See also:
Countershaft Inspection
1. Inspect the gear and bearing contact areas for wear
and damage, then measure the countershaft at points
A, B, and C. If any part of the countershaft is less than
the service limit, replace it.
...
Symptom Troubleshooting Index
When the vehicle has one of these symptoms, check for a diagnostic trouble
code (DTC) with the HDS. If there is no DTC,
do the diagnostic procedure for the symptom, in the sequence listed, until yo ...
A/T Clutch Pressure Control Solenoid
Valve B and C Replacement
1. Do the battery removal procedure (see page 22-92).
2. Remove the battery base (see step 8 on page 5-3).
3. Disconnect the A/T clutch pressure control solenoid
valves B and C connectors.
4 ...