Honda Accord: Torque Converter Housing
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Transaxle / Torque Converter Housing
- Mainshaft Bearing and Oil Seal Replacement
- Countershaft Bearing Replacement
- Secondary Shaft Bearing Replacement
- Selector Control Shaft Oil Seal Replacement
Shift Solenoid Valve Removal and
Installation
NOTE:
-Do not hold the shift solenoid valve connector to
remove and to install the shift solenoid valves. Hold
the shift solenoid valve b o d y .
-Do not install the shift solenoid valve A before ...
Mainshaft Bearing and Oil Seal
Replacement
Special Tools Required
-Adjustable Bearing Puller, 2 5 - 4 0 mm 07736-A01000B
-Driver Handle, 15 x 135L 07749-0010000
-Attachment, 62 x 68 mm 07746-0010500
-Attachment, 72 x 75 mm 07746-0010600
1 ...
See also:
Electrical Compass Zone Selection
and Calibration
NOTE:
• You should do this procedure any time the electrical
compass unit is replaced.
• You should do this procedure in an open area away
from buildings, power lines, and other vehicl ...
If YouMust Drive with Several Children
Your vehicle has a back seat where
children can be properly restrained.
If you ever have to carry a group of
children, and a child must ride in
front:
Place the largest child in the front
se ...
Clutch Interlock Switch T e s t
M/T model
1. Disconnect the clutch interlock switch connector (A).
2. Remove the clutch interlock switch (B).
3. Check for continuity between the terminals according
to the table.
- If the ...