Honda Accord: To Stop Playing a USB Flash Memory Device - Playing a USB Flash Memory Device (Models with navigation system) - Features - Honda Accord 2008-2012 Owner's ManualHonda Accord: To Stop Playing a USB Flash Memory Device

To play the radio, press the FM/AM, or button. Press the CD button button. Press the CD button to switch to the disc mode. Press the AUX button to switch back to the USB.

If you reconnect the same USB flash memory device, the system will begin playing where it left off.

Disconnecting a USB Flash Memory Device

You can disconnect the USB flash memory device at any time even if the USB mode is selected on the audio system. Make sure to follow the USB flash memory device’s instructions when you remove it.

When you disconnect the USB flash memory device while it is playing, the center display and the audio screen (if selected) show NO DATA.

    To Play a USB Flash Memory Device
    This audio system can operate the audio files on a USB flash memory device with the same controls used for the in-dash disc changer. To play a USB flash memory device, connect it to the USB ...

    USB Flash Memory Device Error Messages (Models with navigation system)
    If you see an error message in the center display while playing a USB flash memory device, find the solution in the chart to the right. If you cannot clear the error message, take your vehic ...

    See also:

    Fuel Pipe Protector Replacement
    NOTE: - Put on gloves to protect your hands. - Take care not to scratch the body. - When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage. 1. Remove the le ...

    Emergency Engine Stop
    If you cannot stop the engine by pressing the ENGINE START/STOP button, do either of the following operations: • Press and hold the ENGINE START/STOP button for about two seconds. • Firmly ...

    Glove Box Striker Replacement
    SRS components are located in this area. Review the SRS component locations, 2-door {see page 24-23), 4-door (see page 24-21) and the precautions and procedures (see page 24-25) before doing repair ...