Honda Accord: To Stop Playing a USB Flash Memory Device - Playing a USB Flash Memory Device (Models without navigation system) - Features - Honda Accord 2008-2012 Owner's ManualHonda Accord: To Stop Playing a USB Flash Memory Device

To play the radio, press the FM, AM, or AUX button to switch between disc button. Press the CD/ AUX button to switch between disc mode (if a disc is loaded) and the USB and AUX. On models without XM Radio, press the CD button to switch to the disc mode. Pressing the AUX button switches the audio mode between the USB and AUX.

You can also press the MODE button on the steering wheel to change modes.

If you reconnect the same USB flash memory device, the system will begin playing where it left off.

Disconnecting a USB Flash Memory Device

You can disconnect the USB flash memory device at any time even if the USB mode is selected on the audio system.Make sure to follow the USB flash memory device’s instructions when you remove it.

    To Play a USB Flash Memory Device
    This audio system can select and play the audio files on a USB flash memory device with the same controls used for the disc player. To play a USB flash memory device, connect it to the USB a ...

    USB Flash Memory Device Error Messages
    If you see an error message on the audio display while playing a USB flash memory device, find the solution in the chart to the right. If you cannot clear the error message, take your vehicl ...

    See also:

    Ignition Key Switch Test
    1. Remove the steering column upper and lower covers (see page 20-181). 2. Disconnect the 6P connector (A). 3. Check for continuity between terminals No. 1 and No. 2. • There should ...

    Auxiliary Input Jack
    Use the jack to connect standard audio devices. 1. Open the AUX cover. 2. Connect a standard audio device to the input jack using a 1/8 inch (3.5 mm) stereo miniplug.  - The audio syst ...

    Control Unit Input Test/Replacement
    1. Remove the driver's dashboard lower cover (see page 20-166). 2. Remove the screws, then disconnect the 28P connector (A) from the HandsFreeLink control unit (B). 3. Inspect the connector an ...