Honda Accord: Tire Inspection - Tires - Maintenance - Honda Accord 2008-2012 Owner's ManualHonda Accord: Tire Inspection

Every time you check inflation, you should also examine the tires for damage, foreign objects, and wear.

You should look for:

Bumps or bulges in the tread or side of the tire. Replace the tire if you find either of these conditions.

Cuts, splits, or cracks in the side of the tire. Replace the tire if you can see fabric or cord.

Excessive tread wear.

Your tires have wear indicators

Your tires have wear indicators molded into the tread. When the tread wears down, you will see a 1/2 inch (12.7 mm) wide band across the tread. This shows there is less than 1/16 inch (1.6 mm) of tread left on the tire.

A tire this worn gives very little traction on wet roads. You should replace the tire if you can see three or more tread wear indicators.

    Recommended Tire Pressures
    Normal Driving The following charts show the recommended cold tire pressures for most normal driving conditions. 4-cylinder models V6 models The compact spare tire pressure is: 60 psi (42 ...

    Tire Service Life
    The service life of your tires is dependent on many factors, including, but not limited to, driving habits, road conditions, vehicle loading, inflation pressure, maintenance history, speed, ...

    See also:

    Transmission Number
    Transmission Type 88E5: 5-speed Manual M91 A: 5-speed Automatic B90A: 5-speed Automatic Serial Number 1000001-: M91A, B90A 8000001-: 88E5 ...

    System Check
    1. Connect the HDS to the data link connector. 2. Turn the ignition switch to ON (II). 3. Monitor the SYSTEM CHECK in the IMMOBILIZER INFO with the HDS. 4. If the HDS displays NORMAL N-1,the ...

    Wheel Bearing End Play Inspection
    1. Raise and support the vehicle (see page 1-13). 2. Remove the wheels. 3 . Install suitable flat washers (A) and the wheel nuts. Tighten the nuts to the specified torque to hold the brake d ...