Honda Accord: Tire and Wheel Replacement - Checking and Maintaining Tires - Maintenance - Honda Accord 2013-2026 Owner's ManualHonda Accord: Tire and Wheel Replacement

Replace your tires with radials of the same size, load range, speed rating, and maximum cold tire pressure rating (as shown on the tire’s sidewall). Using tires of a different size or construction can cause the ABS and VSA® (vehicle stability assist) system to work incorrectly.

It is best to replace all four tires at the same time. If that isn’t possible, replace the front or rear tires in pairs.

Make sure that the wheel’s specifications match those of the original wheels.

WARNING

Installing improper tires on your vehicle can affect handling and stability. This can cause a crash in which you can be seriously hurt or killed.

Always use the size and type of tires recommended in this owner’s manual.

    Tire Service Life
    The life of your tires is dependent on many factors, including driving habits, road conditions, vehicle loading, inflation pressure, maintenance history, speed, and environmental conditions (eve ...

    Tire Rotation
    Rotating tires according to the maintenance messages on the information display*/ multi-information display* helps to distribute wear more evenly and increase tire life. Tires with directional ...

    See also:

    Rear Inner Fender Replacement
    NOTE: Take care not to scratch the rear bumper or the body. 1. Remove the screws, then remove the rear inner fender (A) from the rear bumper (B) and the body. 2. Install the inner fender in th ...

    Battery Terminal Disconnection and Reconnection
    Disconnection NOTE: Some systems store data in memory that is lost when the battery is disconnected. Do the following procedures before disconnecting the battery, 1. Make sure you have the anti-th ...

    Navigation Display Unit Removal/Installation
    1 Remove the audio unit (see page 23-114), then remove the center display visor (see page 20-171). 2. Remove the screws and bolts (A), then pull out the navigation display unit (B). 3. Install ...