Honda Accord: Throttle Body
Disassembly/Reassembly
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Fuel and Emissions / Intake Air System / Throttle Body
Disassembly/Reassembly

Throttle Body Removal/Installation
Do not insert your fingers into the installed throttle body when you turn
the ignition switch to ON (II) or while the
ignition switch is in ON (II). If you do, you will seriously injure your finger ...
See also:
Cable Reel Replacement
Removal
1. Make sure t h e f r o n t w h e e l s are a l i g n e d straight
ahead.
2. Do t h e b a t t e r y t e r m i n a l d i s c o n n e c t i o n procedure
(see
page 22-91), t h e n w a i ...
Hood Seal and Hood Molding
Replacement
NOTE: Take care not to scratch the hood.
1. Detach the clips (A) with a clip remover, then remove
the hood seal (B). On Canada models: Detach the clips
(C), then remove the hood molding (D).
2-d ...
Front Door Latch Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the door panel and the inner handle:
- 2-door ( s e e p a g e 20-12)
- 4-door (see page 20-17)
2. Remove the plastic cover, as needed (see st ...
