Honda Accord: Taillight Replacement - Exterior Lights - Body Electrical - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Taillight Replacement

4-door

1 Remove the rear bumper (see page 20-260).

2. Remove the trunk side trim panel (see page 20-132).

3. Disconnect the connectors (A) from the taillights (B).

4 . Turn the bulb sockets 4 5 В° counterclockwise to


4 . Turn the bulb sockets 4 5 В° counterclockwise to remove the bulb sockets (C).

5. Remove the mounting nuts and bolts, then remove the taillight.

6. Remove the screw and separate the taillight and bracket (D).

7. Inspect the gasket (E); replace it if it is distorted or stays compressed.

8. Install the taillight in the reverse order of removal, and tighten the nuts to 5 N-m (0.5 kgfm, 4 Ibf-ft).

2-door

1. Remove the rear bumper (see page 20-260).

2. Remove the trunk side trim panel (see page 20-132).

3. Disconnect the connectors (A) from the taillights (B).

4. Turn the bulb sockets 45 В° counterclockwise to


4. Turn the bulb sockets 45 В° counterclockwise to remove the bulb sockets (C).

5. Remove the mounting nuts and bolts, then remove the taillight.

6. Remove the screw and separate the taillight and bracket (D).

7. Inspect the gasket (E); replace it if it is distorted or stays compressed.

8. Install the taillight in the reverse order of removal, and tighten the nuts to 5 N-m (0.5 kgf-m, 4 Ibf-ft).

    Bulb Replacement
    Headlight (High'Beam) 1. Disconnect the 2P connector (A) from the headlight Headlight (High Beam): 60 W 2. Turn the bulb socket 45 В° counterclockwise to remove the bulb. 3. Install a new b ...

    License Plate Light Replacement
    4-door 1. Poll the license plate light assembly out, and disconnect the 2P connector (A) from the license plate light. License Plate Light: 5W 2. Separate the lens (B) and housing (C), then rem ...

    See also:

    Airbag System Components
    The front, front side, and side curtain airbags are deployed according to the direction and severity of impact. Both side curtain airbags are deployed in a rollover. The airbag system inclu ...

    Upper Arm Replacement
    Special Tools Required -Ball Joint Thread Protector, 10 mm 07AAF-SECA120 - Ball Joint Remover, 28 mm 07MAC-SL0A202 1. Raise and support the vehicle (see page 1-13). 2. Remove the front wheel. ...

    DTC Troubleshooting
    DTC indicator 1: An Open in the Air Mix Control Motor Circuit 1. Turn the ignition switch to LOCK (0), and then to ON (II). 2. Do the self-diagnostic function with the HVAC control unit (see pa ...