Honda Accord: System Setup
This command group allows you to change or customize HFL basic settings.
To set a 4-digit passcode to lock the HFL system for security purposes:
Press and release the HFL Talk button before a command.
1. Say ‘‘System setup.’’ 2. Say ‘‘Security’’ after the prompts.
3. Follow the HFL prompts and say the 4-digit passcode you want to set.
4. Follow the HFL prompts to confirm the number.
NOTE: Once a passcode is set, you will need to enter it to use HFL each time you start the vehicle. If you forget the code, your dealer will have to reset it for you, or youwill have to clear the entire system.
PIN Number
You can add, change, or remove a
PIN number from any phonebook.
To add a PIN:
If you have selected a phonebook
without a PIN, you will see the above
display.
Enter the new 4-digit PIN. You ...
Before Driving
Before you begin driving your
vehicle, you should know what
gasoline to use and how to check the
levels of important fluids. You also
need to know how to properly store
luggage or packages. ...
See also:
MICU Input Test
NOTE; Before testing, troubleshoot the multiplex integrated control unit
first, using B-CAN System Diagnosis Test Mode A (see page 22-134).
Drivers MICU
1. Turn the ignition switch to LOCK (0), an ...
Selector Control Shaft Oil Seal
Replacement
Special Tools Required
-Driver Handle, 15 x 135L 07749-0010000
•Attachment 22 x 24 mm 07746-001A800
1. Remove the oil seal (A) from the end cover (B).
2. Install a new oil seal flush to the ...
ATF Feed Pipe Replacement
1. Remove the snap rings (A), the ATF feed pipes (B),
and the feed pipe flanges (C) from the end cover (D).
NOTE: Replace the end cover, if the 1st clutch ATF
feed pipe (E) replacement is require ...