Component Location Index

...

Transmission Fluid Inspection and Replacement

1. Raise the vehicle on a lift, and make sure it is securely supported. 2. Remove the front splash shield (see page 20-291). 3. Remove the oil filler plug (A) and the sealing washer (B), check ...

See also:

Crossover Network Control Unit Removal/Installation
Driver's Door Speaker Crossover Network Control Unit 1. Remove the driver's dashboard lower cover (see page 20-166). 2. Disconnect the connector (A), then remove the driver's door speaker cross ...

Shift Lock Stop/Shift Lock Stop Cushion Replacement
Type A Shift Lever 1. Remove the shift lock solenoid (see page 14-254). 2. Remove the shift lock stop (A) and the stop cushion (B) as a set. 3. Apply silicone grease to the pin (C) of the shif ...

Low Oil Pressure Indicator Circuit Troubleshooting (Open)
1 Connect the Honda Diagnostic System (HDS) to the data Jink connector (DIG) (see step 2 on page 11-3). 2. Turn the ignition switch to ON (ll). 3. Make sure the HDS communicates with the vehicl ...