Component Location Index

Circuit Diagram

See also:

Countershaft Inspection
1. Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace it. ...

Washer Reservoir Replacement
1. Remove the right inner fender (see page 20-290). 2. Disconnect the 2P connector(s) (A) from the washer motor (B) and the washer fluid level switch (Canada models). Washer Reservoir Capacity: ...

Storing a Driving Position in Memory
Store a driving position only when the vehicle is parked. 1. Turn the ignition switch to the ON (II) position. You cannot add a new driving position to the memory unless the ignition switch ...