Component Location Index

Circuit Diagram

See also:

Countershaft Inspection
1. Inspect the gear and bearing contact areas for wear and damage, then measure the countershaft at points A, B, and C. If any part of the countershaft is less than the service limit, replace it. ...

Low Oil Pressure Indicator
Low Oil Pressure Indicator This indicator should never come on when the engine is running. If it starts flashing or stays on, the oil pressure has dropped very low or lost pressure. Serio ...

Door Key Cylinder Switch Test
1. Remove the driver's door panel (see page 20-17). 2. Disconnect the 10P connector (A) from the door lock actuator (key cylinder switch) (B). 3. Check for continuity between the terminals. ...