Component Location Index

...

Glass Position Adjustment

The roof panel (A) should be even with the glass weatherstrip (B), to within 0+1/— 1 mm (0+0.04/—0.04 in) all the way around. If not make the following adjustment: 1. Remove the brac ...

See also:

Center Display Visor Removal / Installation
Special Tools Required KTC Trim Tool Set SOJATP2014* *Available through the Honda Tool and Equipment Program; call 888-424-6857 Without Navigation System NOTE: - Take care not to scratch the d ...

Piston Ring Replacement
1. Remove the piston from the engine block (see page 7-14). 2. Using a ring expander (A), remove the old piston rings (B). 3. Clean all ring grooves thoroughly with a squared-off broken ring ...

Oil Pressure Switch Test
1 Disconnect the oil pressure switch connector (A) from the oil pressure switch (B). 2. Check for continuity between the oil pressure switch terminal and the engine (ground). There should be con ...