DTC Troubleshooting Index

...

System Description

TPMS Control Unit Inputs and Outputs for 20P Connector Wire side of female terminals System Structure Once the vehicle speed exceeds 28 mph (45 km/h), the TPMS control unit monitors all four ...

See also:

Rear Door Panel Removal/Installation
Special Tools Required -KTC Trim Tool Set SOJATP2014 - Trim Pad Remover Snap-on A 177A, commercially available *Available through the Honda Tool and Equipment Program; call 888-424-6857 4-door ...

System Diagnostic Mode
Start-up procedure and Diagnostic IVieny There are two ways t o enter the diagnostic mode: Method 1 : Start the vehicle. When the globe screen appears, connect the SCS service connector (see page ...

Switch Test/Replacement
1. Separate the lumbar support switch cover (A) from the switch (B). 2. Disconnect the 5P connector (C) from the switch. 3. Check for continuity between the terminals in each switch position a ...