Honda Accord: Switch Test/Replacement
1. Remove the center console panel (see page 20-157).
2. Disconnect the 6P (or 7P*) connector from the seat heater switch, then remove the switch.
*: Front passenger's seat heater switch
3. Check for continuity between the terminals in each switch position according to the table.
NOTE: Make sure the correct test lead (+ or —) is placed on the terminal.
![[ ] : Front passenger's seat heater switch](images/books/642/42/4.html61.gif)
[ ] : Front passenger's seat heater switch
4. If the continuity is not as specified, replace the switch.
Seat Heater Test
Driver's Seat
1. Remove the driver's seat (see page 20-194).
2. Remove the seat back panel.
• 4-door (see page 20-221)
• 2-door (see page 20-213)
3. Disconnect the connector A (4P) ...
See also:
Park Lever Stop Inspection and
Adjustment
1. Set the park lever in the P position.
2. Measure the distance (A) between the park pawl shaft
(B) and the park lever roller pin (C).
Standard: 57.7-58.7 mm (2.27-2.31 in)
3. If the measurem ...
DTC Troubleshooting
DTC B10A2: Driver's MICU (EEPROM) Error
NOTE: If you are troubleshooting multiple DTCs, be sure
to follow the instructions in B-CAN System Diagnosis
Test Mode A (see page 22-134).
1. Clear the D ...
Pandora®
If an error occurs while playing Pandora®, you may see the following error
messages.
If you cannot clear the error message, contact a dealer.
...