Steering

Brakes

See also:

Piston Installation
If the Crankshaft is Already Installed 1. Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. 2. Remove the connecting rod caps, then install the ring co ...

Starting the Engine
1. Make sure the parking brake is applied. 2. Check that the shift lever is in , then depress the brake pedal.  - Although it is possible to start the vehicle in , it is safer to st ...

Differential Thrust Clearance Adjustment
Special Tools Required Driver Handle, 40 mm I.D. 07746-0030100 1 Remove trie left driveshaft side oil seal from the transmission housing (see page 13-70). 2. If you removed the 80 mm shim from t ...