Honda Accord: Sun Visor
To use the sun visor, pull it down.
When using the sun visor for the side window, remove the support rod from the clip, and swing it out.
In this position, the sun visor can be adjusted by moving it on its slider.
Do not use the extended sun visor over the inside mirror.
Make sure you put the sun visor back in place when you are getting into or out of the vehicle.
Accessory Power Sockets
Your vehicle has two accessory
power sockets; one is at the front of
the center console and the other is in
the console compartment.
To use an accessory power socket,
the ignition switch mu ...
Vanity Mirror
To use the vanity mirror on the back
of the sun visor, pull up the cover.
The vanity mirror lights come on
when you pull up the cover. ...
See also:
Oil Pressure Switch Test
1 Disconnect the oil pressure switch connector (A) from
the oil pressure switch (B).
2. Check for continuity between the oil pressure switch
terminal and the engine (ground). There should be
con ...
Master Cylinder Inspection
1. Remove the master cylinder (see page 19-26).
2. Inspect and note these items:
- Before reassembling, check that all parts are free of
dirt and other foreign particles.
- Do not try to disas ...
Symptom Troubleshooting
VSA activation indicator does not go off, and
no DTCs are stored
NOTE: If the VSA modulator was replaced prior to the
activation indicator turning on, do the VSA sensor
neutral position memorizati ...