Honda Accord: Subframe Replacement
Special Tools Required
Subframe Alignment Pin 070AG-SJAA10S
Front Subframe Torque
After removing the subframe mounting bolts, the front subframe middle rubber mount mounting bolts, the front subframe rear stiffener mounting bolts, and the rear engine mounting base bracket mounting bolts, be sure to replace them with new ones.
Front Subframe Alignment
NOTE: Align the front subframe with the subframe alignment pin.
1 Align the front subframe (A) in the following sequence.
-1. Lift the front subframe up to the body, and loosely install the new subframe mounting bolts (B), the front stiffener mounting bolts (C), the new rear stiffener mounting bolts (D) and the stiffeners (E).
-2. Loosely install the new subframe middle mounting bolts (F, G) securing the subframe middle mounts (H).
-3. Insert the subframe alignment pin (I) through the positioning slot (J) on the right rear stiffener, through the positioning hole (K) on the subframe, and into the positioning hole (L) on the body, then loosely tighten the subframe right rear mounting bolt.
-4. Insert the subframe alignment pin through the positioning slot on the left rear stiffener, through the positioning hole on the subframe, and into the positioning hole on the body, then loosely tighten the subframe left rear mounting bolt.
-5. Tighten the subframe mounting bolts to the specified torque values starting with the right rear subframe mounting bolt. Use the subframe alignment pin when tightening the rear side subframe mounting bolts.
-6. Check all of the subframe mounting bolts, and retighten if necessary.
NOTE: Tighten the bolts in the sequence shown.
2. Tighten the bolts securing the subframe middle mounts to the specified torque.
3. After reinstalling all removed parts, check and adjust the front wheel alignment (see page 18-5).
Rear Subframe Torque
NOTE: - Install the rear subframe by aligning the installation positioning holes and positioning holes with the subframe alignment pin.
- Always replace any removed subframe mounting bolts with new ones.
Under-hood Fuse/Relay Box
Removal and Installation Special Tools Required Relay Puller 07AAC-000A1A0 NOTE; The under-hood fuse/relay box is a part of the left engine compartment wire harness, and it cannot be replaced by ...
Engine Type K24Z2: 2.4 L DOHC i-VTEC Sequential Multiport Fuel-injected, 177HP engine K24Z3: 2.4 L DOHC i-VTEC Sequential Multiport Fuel-injected, 190HP engine Serial Number 3000001 -K24Z2 pro ...