Honda Accord: Steering Angle Sensor Replacement - VSA System Components - Brakes - Honda Accord MK8 2008-2012 Service ManualHonda Accord: Steering Angle Sensor Replacement

SRS components are located In this area. Review the SRS component locations: 4-door (see page 24-21), 2-door (see page 24-23) and the precautions and procedures (see page 24-25).

NOTE: Do not damage or drop the combination switch as the steering angle sensor is sensitive to shock and vibration.

1. With the wheels in the straight ahead position and the steering wheel centered, remove the steering wheel (see page 17-6).

2. Remove the steering column covers (see page 20-181) and the cable reel (see page 24-225).

3. Remove the combination switch assembly (see step 7 on page 17-11).

4. Remove the combination light switch (A) and the wiper/washer switch (B) from the combination switch body assembly (C).

5. Install the combination switch body assembly in the reverse order of


5. Install the combination switch body assembly in the reverse order of removal.

NOTE: - Do not remove the steering angle sensor from the combination switch body.

- When installing the cable reel, set the turn signal canceling sleeve position so that the arrow points straight up (see page 24-226).

- Note that the tightening order is specified for the combination switch mounting screws (see page 17-12).

 

    Symptom Troubleshooting
    VSA activation indicator does not go off, and no DTCs are stored NOTE: If the VSA modulator was replaced prior to the activation indicator turning on, do the VSA sensor neutral position memorizati ...

    Yaw Rate-Lateral Acceleration Sensor Replacement
    NOTE: - Do not damage or drop the sensor as It Is sensitive. - Do not use power tools when replacing the sensor. 1. Turn the ignition switch to LOCK (0). 2. Remove the center console (see ...

    See also:

    General Troubleshooting Information
    General Operation Refer to the navigation system manual for the navigation system operating procedures. Anti-theft Feature The navigation system and audio unit have a coded theft protection circu ...

    Changing the Engine Oil and Filter
    Always change the oil and filter according to the maintenance messages shown on the information display. The oil and filter collect contaminants that can damage your engine if they are not r ...

    Climate Control Unit Removal / Installation
    With Navigation 1. Remove the passenger's dashboard undercover (see page 20-170). 2. Disconnect the connectors (A). Loosen the bolt (B) and remove the bolts (C) from the climate control unit (D) ...