Honda Accord: Starter Removal and
Installation
Removal
1 Do the battery removal procedure (see page 22-92).
2. Remove the intake manifold (see page 9-4).
3. Disconnect the positive starter cable (A) from the B terminal, and the S terminal connector (B).
Installation
1. Install the starter, then tighten the two bolts.
2. Install the harness clamp (A).
3. Connect the positive starter cable (B) to the B terminal, and the S terminal connector (C) Make sure the crimped side of the ring terminal faces away from the starter when you connect it.
4. Install the intake manifold (see page 9-6).
5. Do the battery installation procedure (see page 22-92).
6. Start the engine to make sure the starter works properly.
Starter Performance Test
1. Remove the starter (see page 4-11).
2. Firmly clamp the starter in a vise.
3. Make a connection for this test using the thickest
(gauge) wire possible (preferably the same gauge as
used on ...
Starter Overhaul
Disassembly/Reassembly
Armature Inspection and Test
1. Remove the starter (see page 4-11).
2. Disassemble the starter as shown in the Exploded
View.
3. Inspect the armature for wear or dama ...
See also:
A/C Pressure Switch Circuit
Troubleshooting
NOTE:
• Do not use this troubleshooting procedure if any of the
following items are operative: The condenser fan, the
radiator fan, or the A/C compressor, or if the heater is
inoperative. Ref ...
Warranty Coverages
• U.S. Owners
Your new vehicle is covered by these warranties:
New Vehicle Limited Warranty – covers your new vehicle, except for the
emissions control systems and accessories, against defects ...
Security System
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights flashes if
someo ...