Honda Accord: SRS (Supplemental Restraint System)
Eighth generation (2008–2012) / Honda Accord MK8 2008-2012 Service Manual / Restraints / SRS (Supplemental Restraint System)
- Component Location Index
- Precautions and Procedures
- General Troubleshooting Information
- SRS Unit Update
- ODS Unit Initialization
- ODS Unit Operation Check
- Front Passenger's Weight Sensor Output Check After a Vehicle Collision
- Driver's Seat Position Sensor Operation Check
- DTC Troubleshooting Index
- Symptom Troubleshooting Index
- System Description
- Circuit Diagram
- DTC Troubleshooting
- Symptom Troubleshooting
- Component Replacement/Inspection After Deployment
- Driver's Airbag Replacement
- Front Passenger's Airbag Replacement
- Side Airbag Replacement
- Side Curtain Airbag Replacement
- Airbag and Tensioner Disposal
- Cable Reel Replacement
- SRS Unit Replacement
- Side Impact Sensor (First) Replacement
- Side Impact Sensor (Second) Replacement
- Rear Safing Sensor Replacement
- Front Passenger's Weight Sensor Replacement
- ODS Unit Replacement
- Front Impact Sensor Replacement
- Driver's Seat Position Sensor Replacement
- Passenger's Airbag Cutoff Indicator Replacement
Inspection
Out of Vehicle
For front seat belt retractors with seat belt tensioners,
review the SRS component locations, 2-door (see page
24-23), 4-door (see page 24-21) and the precautions and
procedures (se ...
Component Location Index
4-Door
4-Door
2-Door
2-Door
...
See also:
F-CAN Circuit Troubleshooting
1. Turn the ignition switch to LOCK (0).
2. Jump the SCS line with the HDS.
3. Disconnect ECM/PCM connector A (49P).
4. Measure the resistance between ECM/PCM connector
terminals A3 and A4.
...
Crankshaft Inspection
Out-of-Round and Taper
1. Remove the crankshaft from the engine block (see
page 7-14).
2. Remove the crankshaft position (CKP) pulse plate
from the crankshaft (see page 7-30).
3. Clean the cr ...
Shift Solenoid Valve Removal and
Installation
NOTE:
-Do not hold the shift solenoid valve connector to
remove and to install the shift solenoid valves. Hold
the shift solenoid valve b o d y .
-Do not install the shift solenoid valve A before ...