Honda Accord: Special Tools
: Must be used with commercially
available 3/8"-16 slide hammer.
General Troubleshooting Information
How to Check for DTCs with the Honda
Diagnostic S f stem (HDS)
When the powertrain control module (PCM) senses an
abnormality in the input or output system, the D
indicator (A) in the gauge contro ...
See also:
Crankshaft Inspection
Out-of-Round and Taper
1. Remove the crankshaft from the engine block (see
page 7-14).
2. Remove the crankshaft position (CKP) pulse plate
from the crankshaft (see page 7-30).
3. Clean the cr ...
Trim Removal/Installation - Trunk
Lid
Special Tools Required
KTC Trim Tool Set SOJATP2014*
*Available through the Honda Tool and
Equipment
Program; call 888-424-6857
NOTE:
- Put on gloves to protect your hands. .
- Take care not ...
Drive Belt Auto-tensioner
Inspection
Special Tools Required
Belt Tension Release Tool Snap-on YA9317 or
equivalent, commercially available
1. Turn the ignition switch to ON (II), and make sure to
turn the A/C switch OFF. Turn the ign ...